Kobalt 1303497 Mode D'emploi page 18

ASSEMBLY INSTRUCTIONS
7b. Raise the narrowest part of the stand to help align
the holes. Insert spacer (DD) between legs and
secure with M8 x 75mm (2.95") cap screw (AA) and
nut (EE).
Note: DO NOT overtighten. Cut zip tie securing pedal.
Hardware Used
AA
M8 x 75mm (2.95")
CC
Carriage bolt
DD
Spacer
DD
EE
Nut
8. Grasp handles and tilt table saw back onto wheels.
Spacer
Remove table saw from packing tray. Let machine
"stand" and tighten all screws.
2 in. Bolt
Qty. 6
Qty. 2
JJ
Nut
(preassembled
to lower right
leg assembly)
HH
Qty. 2
1 in. hex bolt
Qty. 2
DD
EE
Spacer
Qty. 6
Nut
JJ
Qty. 10
KK
Nut
(preassembled (preassembled
to lower right
leg assembly) leg assembly)
Qty. 2
Washer
(preassembled
to lower right
leg assembly)
Qty. 4
EE
x 2
x 2
Nut
Qty. 10
x 2
KK
Washer
to lower right
Qty. 4
18
kobalttools.com