Care And Maintenance; General Maintenance; Lubrication - Kobalt 1303497 Mode D'emploi

CARE AND MAINTENANCE

• When servicing, use only identical replacement parts. Use of any other parts may create a risk of
personal injury or cause product damage.
• Before performing any maintenance, make sure the tool is unplugged from the power supply and the
switch is in the off position.
• DO NOT at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic.

GENERAL MAINTENANCE

• For best performance use a shop vacuum or blower to keep saw blade area, the dust collection
system, the guarding system and rails free of saw dust and other debris.
• Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to remove
dirt, dust, oil, grease, etc.
• Periodically check all clamps, nuts, bolts, and screws for tightness and condition. Make sure the
throat plate is in good condition and level with the table.
• Check the blade guard assembly after performing maintenance to make sure it is installed correctly
and functioning properly.
• Clean plastic parts only with a soft damp cloth. DO NOT use any aerosol or petroleum solvents.

LUBRICATION

• All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the
life of the unit under normal operating conditions. Therefore, no further lubrication is required.
WARNING
47
kobalttools.com