Airzone CLOUD Manuel D'installation page 49

Temperature Control. Adjusts the set point temperature:
Press the set point temperature to switch between heating and cooling set points. Press
+ or - to manually adjust by increments of
The permitted temperature range is:
•
Heating mode: 15º C – 29º C.
•
Cooling mode: 18º C – 30º C.
In auto mode, there is a minimum difference allowed between heating and cooling set
point temperatures. The system will prevent you from setting a temperature within the
protection range.
Operation mode. To change the Operation Mode, press the Operation Mode icon and
select the mode:
Stop. The air conditioning system will remain switched off. All the terminal elements
(grilles, dampers, etc.) will remain closed.
Ventilation. The system works exclusively in ventilation mode when any zone
generates demand (T
Cool. In this mode, the conditioning unit will start a cooling cycle any time that any
zone is in cool demand (T
Heat. Enables the heating cycle whenever a zone is in heating demand (T
).
room
Dry. Only available in direct expansion systems. The system works in dry mode,
refreshing the zone (reducing the humidity) when any of the zones is generating
demand (T < T
Set-Point
Note: Dry mode decreases humidity in the room by entering the dehumidification cooling
cycle.
Fan Speed. t is used to set the airflow control of the AC unit fan, imposing the flow
depending on the number of zones in demand.
High speed
Low speed
On direct expansion units, enables to directly select the speed of the unit, setting the
value 1 as the lowest speed.
0.5º C.
< T ).
Set-Point room
< T ).
Set-Point room
).
room
Medium speed
Automatic speed
ES
EN
EN
IT
PT
DE
> T
Set-Point
49