Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.13

TOP EXIT

FAILURE TO CREATE A SEAL TO THE FIREBOX WITH THE EXHAUST COLLAR ASSEMBLY WILL CAUSE
THE APPLIANCE TO FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
GX36 ONLY: Natural gas models come equipped with a #43 orifi ce and propane models come equipped
with #54 orifi ces. These orifi ce sizes are suitable for rear vent installations that exit directly out the
wall (no vertical rise). The main burner orifi ce should be changed to the #42 orifi ce for natural gas and
a #53 orifi ce for propane, when venting off the top of the appliance.
NOTE: This appliance has been factory shipped as a rear vent.
A.
Remove the safety screen and glass front, refer to " SAFETY
SCREEN & DOOR REMOVAL / INSTALLATION" section.
B.
Remove the contents from the fi rebox and set aside, you
will need the fl ue collar from the top of the log carton.
C.
To ease assembly, remove the four hex head screws
securing the defl ector from inside the top front of the
fi rebox.
D.
Remove the single screw from the outer cover on the
back of the appliance.
E.
Remove the four screws
intake collar assembly; set the intakecollar and gasket
aside. Careful not to damage gasket.
F.
Remove the single screw from the outer cover with
knockout intact, on the top of the appliance and set
aside.
G.
Remove the inner cover plate and gasket by removing
the four screws. Reinstall the inner cover plate and
gasket onto the back of the appliance.
H.
Take the outer cover (with knockout intact) and secure
onto the back of the appliance.
I.
Remove and discard the 1 1/2" thick batt of insulation.
J.
Place the 7" (178mm) intake collar
and gasket into the top of the
appliance and secure with the four
screws.
K.
Re-install the outer cover (without
knock out) over the 7" (178mm)
exhaust collar assembly and secure.
L.
From inside the fi rebox, install the 4"
(102mm) exhaust collar up through the
top of the fi rebox and secure with the
the four hex head 3/8" thread cutting screws. NOTE: Do not
overtighten. The gasket needs only to be snug against the
fi rebox.
M.
Re-attach the top defl ector, log set, glass door and safety
screen.
WARNING
!
on the 7" (178mm)
I
DEFLECTOR
GASKET
INTAKE COLLAR
ASSEMBLY
OUTER COVER
G
OUTER
F
COVER
(with knockout)
EXHAUST FLUE COLLAR
W415-1401 / D / 05.25.16
25
EN
E
E
D
INNER
COVERPLATE
GASKET

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

B36nteGx36ntGx36nteB36ptB36pteGx36pt ... Afficher tout

Table des Matières