Klarstein 10011485 Mode D'emploi page 13

1. The cooker hood uses high quality materials, and is made with a streamlined
2. Equipped with a large power low noise electric motor and centrifugal leaf, it produces strong
suction, low noise, non stick grease filter and easy to clean.
3. With the isolated low voltage circuit board control, 12vAC input, the lights are therefore safer.
4. Special wind tunnel construction and oil collector design, free dirt will be absorbed in a second.
Installation (10011485/10011486/10011487)
1. The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface
for the best effect. See Pic 1.
2. Install the hook on a suitable place once the installation height is fixed, and keep it in line. The
fixed position of the inside chimney bracket is the place of chimney.
3. Fix the outside chimney bracket on the outside chimney, and be sure that the inside chimney can
be adjusted the height in it freely as well as fixing the extensible pipe. Afterwards, install the
extensible pipe and chimney on the cooker hood. See Pic 3.
4. Put the cooker hood on the hook. See Pic 4.
5. Adjust the height of the inside chimney to the position of the inside chimney bracket and fix on it
by screw,after ajusting the position,fix the body with safety screw. See Pic 5.
Note: The two safety vents are positioned on the back casing, with diameter of 6mm.
Pic 1
Feature
Pic 2
design.
Inside chimney bracket
Hook