Davey EcoSalt 2 DES2-15E Instructions D'installation Et D'utilisation page 12

Once the salt concentration is corrected, the LOW SALT CUT-OUT ALARM must be reset by pushing the
manual ON/OFF button (except for models where the ON/OFF button is deactivated). Alternatively,
the EcoSalt2 will conduct a system check automatically when powered up the next time (if operating via a
separate power supply). Upon start-up if the EcoSalt2 registers a salt concentration within range (refer to
recommended salt range section in the manual), the EcoSalt2 will return to normal operation.
LOW SALT CUT-OUT ALARM is triggered at the following (approximate) salt concentrations:
(If salt levels are in range and water temperature is above 15°C (59°F), your cell may need to be cleaned.)
EcoSalt2 model
DES2-15EL, DES2-25EL
DES2-15USL, DES2-25USL
DES2-15E, DES2-25E, DES2-35E
DES2-15US, DES2-25US, DES2-35US
ADD SALT ALARM AND LOW FLOW ALARM
Should the EcoSalt2 register low flow and a salt concentration below its minimum (refer to recommended
salt range section in the manual), the EcoSalt2 will alarm. The display will toggle between the ADD SALT
ALARM and the LOW FLOW ALARM. In LOW FLOW ALARM, the EcoSalt2 will not produce chlorine. As
shown previously once faults are rectified, normal operation will resume.
OVERRIDING LANGUAGE SETTING
70% – 09:35 AM
CHLORINE OUTPUT
> From the HOME screen, press and hold menu/setting select for 3 seconds.
SETTINGS
1. CLOCK
> Press the menu up/down buttons to scroll down to LANGUAGE;
Low salt cut-out alarm (approx. salt concentration)
1,000ppm (mg/L)
2,000ppm (mg/L)
22
> Adjust language following instructions detailed in INITIAL START UP section, earlier in this manual.
OVERRIDING TIME FORMAT SETTING
70% – 09:35 AM
CHLORINE OUTPUT
> From the HOME screen, press and hold menu/setting select for 3 seconds.
SETTINGS
1. CLOCK
> Press the menu up/down buttons to scroll down to TIME FORMAT;
> Adjust time format following instructions detailed in INITIAL START UP section, earlier in this manual.
DISPLAY ALARM HISTORY
The EcoSalt2 keeps a history log for the user that registers the number of hours during which the EcoSalt2
is in alarm mode. As a reminder, the cell life expectancy will be reduced if the EcoSalt2 is run with salt
concentrations outside of the recommended range.
70% – 09:35 AM
CHLORINE OUTPUT
> From the HOME screen, press and hold menu/setting select for 3 seconds;
23