Features of the RX 750 LCD
Designed to charge 1 to 4 pcs AA/HR6 or AAA/HR03 rechargeable
•
NiMH batteries. Also suitable to charge the new generation NiMH
'Ready to Use' batteries. These two battery sizes can be mixed in
the charging unit.
An intelligent microprocessor controls the charging process of every
•
single cell.
Four independent charging channels with automatic charging current
•
selection for the different battery sizes (AA 450mA – AAA 200mA).
LCD screen shows charge status of every cell, with bad or non-
•
rechargeable (primary) cell indication.
Switching type power supply for voltage from 100-240V AC for
•
international use.
Cut off & charge control functions
To avoid overcharging, the microprocessor interrupts the current to
each charging compartment when:
full charge of the battery is detected while measuring the -dV
•
the safety timer has reached the preset time of 6.5 hours
•
The RX 750 LCD is equipped with safety features against :
short circuit
•
reversed polarity (+) and (—)
•
recharge of non-rechargeable or defective batteries.
•
Table of average charging times
These are indicative figures as charging time depends on the capacity,
•
age and brand of the battery.
The charging times are based on a full charge of empty batteries. The
•
security timer will interrupt charging after ± 390 minutes.
17
GB