FLIR C336ZC1 Manuel D'utilisation page 13

5
Installation
5. Run the cables from the camera through the bracket connector and the
wall mounting bracket. Insert the camera until it is flush with the bracket
connector, then use the included Allen key to tighten the bracket connec-
tor bolts (3x) to secure the camera.
6. Mark holes for the mounting bolt sets (4x) through the wall mounting
bracket, then mark a hole for the camera cable in the center of the mount-
ing bolt markings. Drill where marked.
7. Disassemble the mounting bolt sets (4x). Place the anchors (4x) on the
mounting bolts (4x) with the expandable side on the wide end of the bolt.
Insert the wide end of the mounting bolt assembly into the wall and tap the
bolts into the wall with a hammer.
1. Mounting Bolt (4x); 2. Anchor (4x)
8. Connect the camera cables as detailed in 4 Connecting the Camera, page
4.
#LX400046; r. 2.0/22386/22410; en-US
9