Activating Standby Mode - Grant Optima TX150 Mode D'emploi

directly on the unit or through Grant Labwise™ software. See section 5.3.2 for
information on program configuration via the unit (TXF200 only). When a program is
running icon access is limited to the standby and program functions

.
°c
 
 
. :
To stop a program
1. Rotate the dial until the program icon is highlighted, press the S button.
If no key is pressed for 10 seconds or if F is pressed, the program icon is no longer
active and will remain at its original value and the program will continue to run.
2. Rotate the dial until the "–" is displayed, press S to select
The program will stop. The display will remain at the set temperature reached when
the program was stopped, the countdown timer will stop at the remaining time and
the pump speed will display the last speed set.

5.2.14 Activating standby mode

In standby mode the TX150/TXF200 is still powered, however key functions (heating,
pump, countdown timer and programs) are switched off. In standby mode access is
limited to the settings menu, enabling the functions such as alarms and programs to be
configured while the unit is not operating.
Note. When entering standby mode the pump will remain on for 5 minutes to allow
internal cooling to continue.
If a countdown timer has been set or a program is running before activating standby
mode they will be terminated.
TX150 & TXF200
Operating Manual
1. Rotate the dial until the program icon is
highlighted, press the S button.
°c
If no key is pressed for 10 seconds or if F is
pressed, the program icon is no longer active and
will remain at its original value.
2. Rotate the dial until the desired program is
displayed (TXF200 = 1 to 10). By default the
TX150/TXF200 will display program "–" indicating
that no program is selected. Press S to select the
program.
The selected program will start. The display will
show the target temperature of the first segment
and the countdown timer will indicate the duration
of the program remaining. The TXF200 will display
the pump speed set for the first segment. Whilst a
program is running only the Standby icon can be
selected.
At the end of a program the buzzer will sound, this
can be cancelled by pressing F or S.
www.grantinstruments.com
EN
30424 V3
Page 18