Pioneer Premier PRS-D1000M Mode D'emploi page 12

Connecting the Unit
Four Amplifier (Ex. Bridge)
2 Ω to
16 Ω
MODE SELECT switch must
be in SYNC INV position.
• Only use speakers having an impedance of 2 Ω to 16 Ω. In addition, in the case of connecting multiple
speakers with a bridge, check that the synthetic impedance is at least 2 Ω.
• The setting of the POWER MODE switch varies according to the speaker impedance. Slide the POWER
MODE switch to the HI-CURRENT position if the impedance is from 2 Ω to less than 4 Ω, or slide it to the
NORMAL position if the impedance is from 4 Ω to 16 Ω. The same setting is used for four amplifiers.
• When switching to the SYNC INV mode, the seal over the MODE SELECT switch must be peeled off and
you can find SYNC INV switch. Peel off the seal after checking that connections are correct.
11
MODE SELECT switch
must be in MASTER position.
Connecting speaker
wire (sold separately).
MODE SELECT switch must
be in SYNC INV position.
MODE SELECT switch must be
in SYNC INV position.
Connecting speaker
wire (sold separately).
SYNC OUTPUT
Connecting wire with RCA
pin plugs (sold separately).
SYNC OUTPUT
Connecting wire with RCA
SYNC INPUT
pin plugs (sold separately).
SYNC OUTPUT
SYNC INPUT
Connecting wire with RCA
pin plugs (sold separately).
SYNC INPUT
Connect to a car stereo.
For details, see the
"Connection Diagram".