Adjusting The Lamp - LUCTRA 9235 Mode D'emploi

• Power supply unit with plug-in connector
• Power cable with Euro plug
• Power cable with UK plug-in connector, type G
• Microfibre cloth
• Hexagonal socket-head screws 2×
• Torx screws 2×
• Allen key 1×
• Torx screwdriver 1×
Note:
Please contact our service team if one of the parts are missing or damaged.
Assembly
– Take all pieces out of the packaging.
Note:
The base plate (6) is housed in a cardboard insert.
– Pull out the cardboard insert and remove the base plate (6).
▶ see image 2
– Screw the lower section of the light (5) to the base plate (6) using the supplied hexagonal
socket-head screws (7).
▶ see image 3
– Connect the two plugs (8) and (9) and fit the upper section of the light (3) to the lower sec-
tion (5).
Note:
The upper section of the light (3) can only be fitted fully in own direction.
▶ see image 4
– Secure the upper section of the light (3) with the supplied Torx screws (10).
Connecting the electrics
▶ see image 5
1. Connect the connecting cable of the lamp to the power supply unit.
Note:
You must first release the plug lock (11) to disconnect the lamp and power supply unit.
2. Connect the power cable that matches the power supply to the power supply unit:
– Power cable with Euro plug (12)
– Power cable with UK plug-in connector (13)
3. Insert the plug into the socket.

Adjusting the lamp

NOTICE!
Risk of damage to the lamp!
Do not rotate the lamp head against the resistance in the swivel joint.
EN
English
LUCTRA | 17