Problem Solver - IKEA W10748907C Instructions D'utilisation

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, visit
http://www.whirlpool.com/product_help. In Canada, visit http://www.whirlpool.ca.
PROBLEM
Nothing will operate
Surface burners will not
operate
Surface burner flames are
uneven, yellow and/or
noisy
Excessive heat around
cookware on cooktop
Cooktop cooking results
not what expected
Oven will not operate
Oven burner flames are
yellow or noisy
Oven temperature too high
or too low

PROBLEM SOLVER

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
POSSIBLE CAUSES AND/OR SOLUTIONS
Power supply cord is unplugged - Plug into a grounded 3 prong outlet.
Household fuse is blown or a circuit breaker is tripped - Replace the fuse or reset the circuit breaker.
If the problem continues, call an electrician.
Main or regulator gas shutoff valve is in the off position - See the Installation Instructions.
The range is improperly connected to the gas supply - Contact a trained repair specialist or see the
Installation Instructions.
The control knob is not set correctly - Push in knob before turning to a setting.
Air in the gas lines - If this is the first time the surface burners have been used, turn on any one of the
surface burner knobs to release air from the gas lines.
Clogged burner ports - See the "Sealed Surface Burners" section.
Clogged burner ports - See the "Sealed Surface Burners" section.
Burner caps positioned improperly - See the "Sealed Surface Burners" section.
Range converted improperly - If propane gas is being used, contact a service technician or see the
cover for contact information.
Cookware and flame are not matched - The cookware should be centered above the burner with the
bottom sitting level on the grate. The flame should be adjusted so that it does not extend up the sides of
the pan.
Improper cookware - Ideal cookware should have a flat bottom, straight sides and a well fitting lid, and
the material should be of a medium to heavy thickness.
Control knob set to incorrect heat level - See the "Cooktop Use" section.
Range is not level - Level the range. See the Installation Instructions.
Air in the gas lines - If this is the first time the oven has been used, turn on any one of the surface
burner knobs to release air from the gas lines.
Control is locked - Press and hold START LOWER for 3 seconds to unlock.
Control is in Demo Mode - See the "Electronic Oven Controls" section. Demo Mode is used for display
models in a showroom.
Electronic oven control set incorrectly - See the "Electronic Oven Controls" section.
Range converted improperly - If propane gas is being used, contact a service technician or see the
cover for contact information.
Oven temperature needs adjustment - See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
15