Connecting The Water Line - Dacor DRF36 Série Instructions D'installation

Installation instructions

15. Connecting the Water Line

To prevent leaks and water damage, be careful not to kink the water line.
After connecting the water hose on the floor, open the water valve in the rear of the
appliance and check the connection of the water supply line and make sure there is no
leak.
There are several items you must purchase to complete this connection. You may find
these items sold as a kit at your local hardware store.
Copper Tubing
Plastic Tubing
1. Remove the cap from the appliance connection.
2. Bend the water line according to the location of the connection on the appliance.
3. Slide the union nut and seal onto the water line.
4. With the open-end wrench, tighten the union nut, being careful not overtighten.
5. Open the shut-off valve and main water tap.
6. Check the connection on the shut-off valve and on the appliance for leaks.
7. Push the water line into the guard tube as far as possible.
Water Filter
English
46
• / " copper tubing
1
4
• / " compression nut (1 pc)
1
4
• Ferrule (2 pc)
• / " plastic tubing  Molded end (Bulb)
1
4
• / " compression nut (1 pc)
1
4
Water Outlet
(Home)
Water Outlet
(Appliance)