Maintenance - Pond Boss 52354 Instructions D'utilisation

MAINTENANCE

Regular cleaning of the pump may be necessary depending upon the
environment in which it is operated. Clean the pump when it is visibly soiled
or when a drop in performance is detected. Clean your pump in 5 easy steps!
Step 1. Before cleaning, always
disconnect the pump from the
power source and remove the
inlet screen.
Step 2. Remove the impeller
housing to expose the impeller
assembly.
Step 3. Remove the impeller
assembly by gently pulling
on the impeller blades. The
impeller is held in place by a
manget
Step 4. Use a soft cloth or
brush and warm water to clean
the impeller, the inside of the
impeller housing and the rotor
housing.
Step 5. Reassemble all pump
parts and place in water before
reconnecting to the power
source.
TROUBLESHOOTING
IF THE PUMP FAILS TO OPERATE:
• Check to make sure the power cord is plugged in; the pump is getting power.
• Check the pump outlet and any tubing, nozzles, spitters etc. for kinks or
obstructions.
• Remove the inlet screen and/or pump cover, and impeller housing to expose
the impeller. Turn the impeller to ensure that it is not broken or jammed.
IF THE PERFORMANCE OF THE PUMP IS NOT SATISFACTORY OR THE PUMP
DOES NOT FLOW EVENLY:
• Check to make sure the pump is completely submerged in water.
• Check to make sure the impeller and the housing are clean.
• Adjust flow control.
For more information on product maintenance and maintenance
videos, visit www.thepondboss.net
4
VISIT WWW.THEPONDBOSS.NET FOR PRODUCT INFORMATION AND TIPS.
1
3
5
2
4