Fig. 1; Lcd Display; Service & Maintenance; Lubrication - Ferm FPCD-1800I Mode D'emploi

Switching the device on and off

Fig. 1

• Depress the on/off switch (5). It regulates the
speed of the appliance by transmitting power
to the switch.
• Release the on/off switch (5) to halt the drill
chuck immediately, it will no longer run on.
• Move the direction reversing switch (4) to the
centre in order to lock the appliance in its
disabled state.
The drill will turn at its slowest speed when the
switch is depressed lightly. The drill will turn at its
fastest speed when the trigger is fully depressed.
Only lay down the appliance when it has stopped
running completely. Do not place it on a dusty
surface as particles of dust could get into the
mechanism.

LCD display

Fig. 4
This Impact drill is equipped with an LCD display
(2) on top of the drill housing
• To turn the display on, press the display button
(27) once. To turn the display off, press the
display button again.
• The light icon (25) will become visible when
the LED work lights are turned on.
• The clock (28) and minutes (24) remaining
icons indicate the number of minutes of
running time that are available before the
battery requires recharging (Lithium Ion
battery only)
• The battery icon (23) indicates the amount of
charge remaining in the battery. Each charge
bar displayed indicates approximately 10%
charge remaining in the battery. A total of 10
charge bars indicates a fully charged battery.
5. SERVICE & MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
The machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Ferm
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.

Lubrication

The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. Separate you find an exploded view
showing the parts that can be ordered.
Environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material.
Therefore please make use of options for recycling
the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Warranty
The warranty conditions can be found on the
separately enclosed warranty card.
GB
7