Installing The Ezhitch Tm With A Quick-Release - Thule Coaster Instructions

4.8.2 InstallIng the ezhItch
QuIck-Release
A. Verify that the quick release skewer is compatible with
your bicycle.
B. Completely unscrew and remove the quick-release
knob from the quick release skewer.
C. Remove one of the springs from the quick-release skewer.
D. Insert the quick-release skewer through the ezHitch™.
(See image 1)
E. Insert the quick-release skewer into the bicycle axle
from the left side pointing right.
F. Replace the spring back onto the quick-release skewer,
narrow end pointing inwards, towards the bicycle.
G. Close the quick-release lever.
H. Replace and tighten the quick release knob until
thumb tight.
I. Open the quick-release lever. (See image 2)
J. Tighten the quick-release knob another full turn.
K. Close the quick-release lever. (See image 3)
L. Verify that the bicycle wheel is securely attached to
the bicycle by giving it a sharp pull.
WARNING
The quick-release knob must be tightened on
the quick-release skewer completely with at
least two screw threads showing past the end
of the quick-release knob to ensure the rear
wheel of the bicycle does not loosen off.
Always make sure that the quick-release is
correctly attached. An incorrectly tensioned
quick-release may lead to accidental loosening
of the rear wheel.
12
wIth a
tM
1
2
3
51100985 - A