Raid Setup Procedure - Monster ABRA A5 V16.7 Mode D'emploi

RAID Setup Procedure

1. Start-up your notebook computer and press F2 to enter the BIOS and go to the Setup
Utility.
2. Select the Advanced menu.
3. Select SATA Mode, press Enter and select Intel RST Premium... and select <OK>.
4. Press F10 to "Save and Exit" and select <Yes>.
5. After the computer restarts press F2 to enter the BIOS again and go to the Setup Utility.
6. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and select "Create
RAID Volume".
7. You can now setup your RAID volume using the installed SSDs.
8. Select "Name" and type a name of your choice for your RAID volume and select <Yes>.
9. Select "RAID Level" and choose the RAID Level required (see Table 1 on page 7) and
press Enter.
•
RAID 0 (Stripe)
•
RAID 1 (Mirror)
10. Go to any of the disks listed under Select Disks: and select a disk name.
11. Click on X to select the disk required.
12. You should select two identical SSDs to form your RAID volume.
13. If you have selected RAID 0 (Stripe) then you can adjust the "Strip Size" to your
requirements (It is recommended that you set the "Strip Size" to 128KB).
14. Select "Create Volume" (make sure you have selected your disks).
15. The system will list your RAID volume.
16. Press F10 to "Save and Exit" and select <Yes>, however note below.
• Make sure the Windows 10 OS DVD is in the attached DVD drive and as the computer
starts up it will automatically boot from the Windows 10 OS DVD (you will be prompted to
press a key to boot from the DVD).
17. Click Next > Install Now to continue installing the operating system as normal (see
your Windows documentation if you need help on installing the Windows OS).
18. Follow the on-screen instructions to install the Windows 10 operating system.
19. Install the Windows drivers. Make sure you install the Intel® Rapid Storage Technology
(IRST) driver.
EN
09