Range Of Use; Technical Data - SPIDO X120/50 PROTEC Mode D'emploi

Any nonobservance of this instruction bears the risk of an electrical shock which may cause
damage to persons or property.
Please inspect the device for damage occurred during transportation. In case of damage, the retailer has to be
informed immediately, at the latest within 8 days after the date of purchase.

2. Range of use

Booster sets from SPIDO are self-priming electrical pumps with a mechanical or electronic pump control system for
automated operation. These high-quality products with their convincing performance data were developed for the
various purposes involved with irrigation, domestic water supply and pressure boosting, as well as for discharging
water at a constant pressure. The devices are suitable for pumping clean, clear water.
The typical areas of use of booster sets include: Automatic domestic water supply with grey water from wells and
cisterns, automated irrigation of gardens and garden beds and sprinkling, pressure boosting within the domestic
water supply system.
The device is not suited for use in swimming pools.
This product is intended for private use in the home area and not for commercial or industrial purposes or for
continuous circulating.
The pump is not suited to discharge saltwater, faeces, inflammable, etching, explosive or
other hazardous liquids. Please observe the max. and min. temperatures of the liquids to be
discharged stated in the technical data.

3. Technical Data

Model
Mains voltage / frequency
Nominal performance
Protection type
Suction port
Pressure port
1)
Max. flow rate (Q )
max
3)
Max. pressure
1) 3)
Max. delivery height (H )
max
Max. suction height
Volume of the pressure tank
Max. size of the solids being pumped
Max. permissible operating pressure
Min. ambient temperature
Max. ambient temperature
Min. fluid temperature
Max. fluid temperature (T )
max
Max. cut-in frequency in one hour
Length of connection cable
Cable type
Weight (net)
Guaranteed sound power level (L
Measured sound power level (L
2)
Sound pressure level (L )
pA
Dimensions (L x D x H)
Item no.
1)
The values were determined with free, unreduced in- an outlet.
2)
Noise emission values obtained according to the EN 12639 regulation. Measurement method according to
EN ISO 3744.
3)
Due to the factory pre-set switch off pressure of the pressure switch, pressure is limited to approx. 3.5 bar (35
m delivery head). The theoretically achievable pressure of the pump unit of the domestic water supply can
reach the value specified under "Max pressure". Consult a qualified specialist, to adapt the pressure circuit
to your requirements if necessary, see also the chapter "Setting the pressure switch".
X120/50 PROTEC
230 V ~ 50 Hz
1,200 Watt
IP 44
30.93 mm
30.93 mm
4,400 l/h
5.0 bar
50 m
9 m
50 l
3 mm
6 bar
5 °C
40 °C
2 °C
35 °C
40, evenly distributed
1.5 m
H07RN-F
~ 16,4 kg
2)
86 dB
)
WA
2)
84.5 dB
)
WA
78.9 dB
51 x 29 x 61 cm
002156
, female
(1 ")
, female
(1 ")
2
X80/20 PROTEC
230 V ~ 50 Hz
800 Watt
IP 44
30.93 mm , female
(1 ")
30.93 mm , female
(1 ")
3,300 l/h
4.6 bar
46 m
9 m
22 l
3 mm
6 bar
5 °C
40 °C
2 °C
35 °C
40, evenly distributed
1.5 m
H05RN-F
~ 13.4 kg
81dB
77,4dB
69,4dB
51 x 29 x 58 cm
002136