ENGLISH
2. The C300BRS4A Explained
• Front Panel
Nr
Description
1
Power LED
2
Status LED
3
WAN LED
4
WLAN LED
5
LAN LED's
(1,2,3,4)
6
WPS LED
7
WPS Button
*
In normal use, the Status LED will turn on and blink within 45 seconds after the device is turned on
or restarted. When a system failure happens with the device, the Status LED will not turn on.
You can use the following options to solve the system failure:
a.
Power down the device, wait 10 seconds and reconnect the power to the device.
b.
Reset the device to factory defaults by pressing the reset button on the back of the device for
+/- 15 seconds.
If the Status LED does not turn on after you tried above options, please contact Conceptronic
Support at: support@conceptronic.net
**
For more information about the WPS feature, see Chapter 6 of this Guick Installation Guide.
7
6
Status
Status Explanation
OFF
The device is turned off
ON
The device is turned on
OFF
The device is turned off / System Failure*
BLINK
The device is turned on and ready for use
OFF
No WAN Connection is created
ON - STEADY
A WAN Connection is created
ON - BLINK
Data is sent or received through the WAN Port
OFF
Wireless interface is disabled
BLINK
Wireless interface enabled and active
OFF
No Network Link is created to the LAN Port
ON - STEADY
A Network Link is created on the LAN Port
ON - BLINK
Data is sent or received through the LAN Port
ON – BLINK
When the WPS Button is pressed, the WPS LED will blink for
120 seconds while searching for WPS Clients. **
Press the WPS Button to activate the WPS feature. The
router will search for WS Clients for 120 seconds. **
4
5
27
3
2
1