T R O U B L E S H O O T I N G; Faults - Causes And Remedies - CS Unitec MAB 525 Mode D'emploi

T r o u b l e s h o o t i n g

F a u l t s - c a u s e s a n d r e m e d i e s
F a u l t
The motor does not start
after pressing the ON/
OFF switch or stops during
operation .
The automatic circuit
breaker in the electrical
distribution board trips
The magnetic clamp does
not function .
The lubrication system
does not function .
NOTE
► If you cannot resolve the problem with the steps described above, please contact
After-Sales Service .
M AB 5 2 5
Po s s i b l e c a u s e
Plug not inserted into socket .
Automatic circuit breaker
tripped .
The magnetic clamp is not
switched on .
The internal safety switch
has switched off the machine
due to overheating .
Direction of rotation not
selected .
The torque cut-out has
tripped .
Too many appliances con-
nected to the same power
circuit .
Machine is defective .
Magnet not switched on .
The surface is not magnetic .
No lubricant available .
Lubricant tap closed .
Connecting nipple clogged .
T r o u b l e s h o o t i n g
R e m e d y
Insert plug .
Switch on the automatic circuit
breaker again .
Switch on the magnetic clamp .
Allow the machine to cool
down .
Preselect direction of rotation .
Switch the machine off and on
again .
Reduce the number of appli-
ances on the power circuit .
Contact After-sales Service .
Switch on magnet .
Use a suitable base .
Top up the lubricant .
Open the lubricant tap .
Clean tank and nipple .
2 9