Schulthess Perla GS 55i Swiss eMotion Notice D'utilisation page 49

Using the detergent
A B
30
20
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when, af-
ter the activation:
• All the programme indicators come on
• The display shows 2 horizontal status
bars.
If the control panel shows other conditions,
press the cancel button until the appliance
is in setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance.
4. Make sure that the appliance is in set-
ting mode.
5. Press one of the programme buttons
again and again until only the indicator
of the programme that you want to set
is on.
• The programme duration flashes in
the display.
6. If you want, you can set the options.
7. Close the appliance door. The pro-
gramme starts.
• The display shows the programme
duration that decreases with steps of
1 minute.
Starting a programme with delay start
1. Set the programme and the options.
A
-
+
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
2. Press the delay button again and again
until the display shows the delay time
you want to set (from 1 to 24 hours).
• The delay time flashes in the display.
3. Close the appliance door. The count-
down starts.
• The display shows the countdown of
the delay start that decreases with
steps of 1 hour.
• When the countdown is completed, the
programme starts.
You can set a programme, options and
the delay start also with the appliance
door closed. In this condition, you only
have 3 seconds after each setting be-
fore the appliance starts to operate.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
Press the cancel button until all the pro-
gramme indicators come on. The appliance
goes back to setting mode, you have to set
the programme again.
Cancelling the programme
Press the cancel button until all the pro-
gramme indicators come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
49