Direct Monitoring - Samson STUDIO GT Mode D'emploi

Direct monitoring

1. To send a mono mix from the CHANNEL 1 and CHANNEL 2 inputs to the Studio
GT speakers and headphone outputs, set the MONO/STEREO button to the up,
MONO position.
2. To separate the mix from the CHANNEL 1 and CHANNEL 2 inputs to the Studio
GT speakers and headphone outputs, set the MONO/STEREO button to the down
STEREO position. CHANNEL 1 will be heard in the LEFT speaker and CHANNEL 2
will be heard in the RIGHT speaker.
3. The input signals are mixed with the output signal from your DAW. The MONO/
STEREO switch does not affect the inputs of your audio software.
4. To balance the signals from the front panel inputs with the output signal from
your DAW, adjust the MIX control until you find the desired mix. When the MIX
control is turned fully counter-clockwise, only the input signal will be heard.
When the MIX control is turned fully clockwise, only the audio coming from the
computer will be heard.
Owner's Manual
Studio GT Quick Start
Studio GT
15