Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
STEP 1: Attach Wheels to Hopper Assembly
1.
As per Pic. 1, assemble a Flat Washer Ø12, a Bushing, a Poly Wheel on one end of
the wheel axle, which as a Ø3 hole. Then go on assembling a Flat Washer Ø12, at
this moment, please insert a Cotter Pin Ø3X30 into the Ø3 hole on the wheel axle
and make the cotter bent for locking.
2.
Assemble a Flat Washer Ø12, a Bushing, a Poly Wheel at the other end of the wheel
UK
axle. Turn the wheel till the Ø5 hole on the wheel is in the same line with the Ø5
hole on the wheel axle, insert the Cotter Pin Ø5X45 and make it bent for locking.
Step 2: Attach Support Legs to Hopper Assembly
1.
As per Pic. 3, insert two Hex Bolt M6X35 with Big Flat Washer Ø6 from the inner
hopper and a leg, then locked by two Wing Nut M6. Tighten the nuts.
2.
Using the same way to assemble the other leg. See Pic.4.
6
Publicité
Table des Matières
