MAC Audio MPS 801 Mode D'emploi page 28

SELECTING AND SAVING STATIONS MANUALLY
• Hint: Before beginning to tune in stations manually, obtain the available DAB / DAB+ stations
channel / frequency information for your area.
• Switch on the appliance.
• Press SOURCE button on the remote control or on the appliance repeatedly to choose DAB
mode. [FULL SCAN] is shown in the display.
• Press the TUN- / TUN+ buttons until [MANUAL] is shown in the display. Press
• Now you will see 5A 174.928MHz in the display.
• Press the TUN- / TUN+ buttons to display a particular channel / frequency, the display will
show the channels from SA to 13F and the associated frequencies.
• When the desired channel is displayed, press the
displayed. To add the channel, press the
• Add additional channels in the same way and then press the MENU button to exit manual
tuning mode.
• The radio will return to the first station and the new stations will be added.
• Use the TUN- / TUN+ buttons to move through the stations available and press the
to listen to the station.
Note: Up to 30 stations can be saved.
AUTO-SCAN AND STORE PRESET STATIONS
• Switch on the appliance.
• Press SOURCE button on the remote control or on the appliance repeatedly to choose DAB
mode.
• Press the MENU button. [FULL SCAN] is shown in the display.
• Press button and the unit starts scanning DAB / DAB+ stations around your area.
Scanning O is shown in the display.
• Once the scan is completed, the radio returns to play the previously-selected station or first
station on the station list.
• Use the TUN- / TUN+ buttons to move through the stations available and press the
to listen to the station.
RESET DAB SETTINGS
• Switch on the appliance.
• Press SOURCE button on the remote control or on the appliance repeatedly to choose DAB
mode.
• Press the MENU button. [FULL SCAN] is shown in the display.
• Presses the TUN- / TUN+ buttons repeatedly until [SYSTEM] is displayed then press the
button to confirm, now [RESET] will be displayed.
RESET DAB SETTINGS
• Press the button [RESET N] will be displayed, use the TUN- / TUN+ buttons to toggle to
[RESET Y] and then press the
• Once the reset is completed, the unit will then automatically perform a full scan. All
previously stored stations will be lost during reset.
button again.
button to start the reset process.
28
button and the signal strength will be
to confirm.
button
button