MAC Audio MPS 801 Mode D'emploi page 21

3 EJECT: Opens or closes the CD compartment.
4 SLEEP/TIMER: Set automatic shutdown time. Alarm timer.
Alarm setting
Before the alarm can be set, the clock must be set.
Alarm setting: In standby mode, press and hold the button TlMER for 2 seconds.
The hour indication is flashing, set the hours with the buttons
the TIMER button.
Now the minutes indication is flashing, set the minutes with the buttons
confirm with TIMER button.
The source playback is now flashing in the display, now set the source playback with the
buttons and
The alarm volume is now flashing in the display, now set the alarm volume with the buttons
and and confirm by pressing TIMER button.
The alarm is now set and activated, in the display TIMER is indicated.
Switch off alarm: Press the button TIMER in standby mode, TIMER will disappear.
Automatic shutdown (sleep)
When the appliance is in active mode, you can switch off the appliance automatically after a
preset time {between 90 and 10 minutes).
When the sleep timer is set, the SLEEP indicator is shown in the display. Press SLEEP button
repeatedly to set the desired shut down time in 10 minute sequence from 90 to 10 minutes.
Cancelling the sleep function: Press SLEEP button repeatedly until OFF appears on the
display.
The settings are saved automatically after 5 seconds of inactivity.
5 SOURCE: Switch input source: CD, USB, DAB, FM, AUX, LINE IN, BT
6 LED: Switch the speaker illumination:
2 x blue/red flickering - red, - green - blue - yellow/green - purple - turquoise - OFF
7 PROG: To select a memory preset or to store a station.
FM operation:
A total of 30 FM stations can be stored in the memory.
• Select the desired station (FM). Open the memory using the PROGRAM button on the
remote control (7) by 3 seconds operation.
• Choose the desired station number by TUN+/- .
• The station number flashes in the display.
• Press the PLAY/PAUSE button again to store the station.
• The station number stops flashing.
• Repeat this procedure to store other stations
CD operation:
Programming the playback sequence when not running playback from a CD:
• Press the PROG button.
• Press SKIP FORWARD or SKIP BACK to select the desired track.
• Press PROG to confirm your selection.
• Select the next track. Up to 20 tracks can be stored in the playlist.
• Press PLAY to start playback of the programmed list.
and confirm by pressing TIMER button.
21
and and confirm with
and and