Monitor Audio C280-IDC Guide D'installation page 5

Fitting the Custom Install Loudspeakers
1 Draw around template and mark centre lines if necessary
c u t o u t t e m p l a t e
Diameter: 170mm (6 11/16 ")
Template
99mm
(3 7/8 ")
Connect speaker cables by pushing down on the
3
terminals and clamping the bare wire in the through hole.
Tighten Tri-Grip screws.
5
See over tightening warning.
Images for illustration only
2 Cut around marked line
Guide speaker into cut out
4
Fit grilles. They are held in place magnetically and should
6
'snap' into place.
monitoraudio.com 3