Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
must be more than 10cm. Keep a distance to any flammable objects of at least 12m.
• Operate the device only after having familiarized yourself with its functions. Do not permit ope-
ration by person not qualified for operating the device. Most damages are the result of unprofes-
sional operation.
• Please use the original packaging if the device is to be transported.
• For safety reasons, please be aware that all modifications on the device are forbidden. Further-
more, any other operation may lead to short-circuit, burns, electric shock, lamp explosion, crash,
etc. If this device will be operated in any way different to the one described in this manual, the
product may suffer damages and the guarantee becomes void.
RIGGING
• This fixture may be mounted in any position, provided there is adequate room for ventilation
• It is important never to obstruct the fan or vents pathway.
• When selecting installation location, take into consideration lamp replacement access and rou-
tine maintenance.
• Safety cables must always be used.
• Never mount in places where the fixture will be exposed to rain, high humidity, extreme tempe-
rature changes or restricted ventilation.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
INSTALLATION INSTRUCTIONS
Installation/replacement of lamp
• Do not turn the unit on if no lamp is fitted or if the lamp is burnt out.
• Disconnect from mains during lamp installation
• Please note: Under normal operating conditions, the housing may reach 60°C.
• The lamp becomes very hot during operation. When you switch the lamp off, don't unplug it from
the mains; Wait at least for 15 minutes to let the lamp cool down otherwise you might cause a
high voltage discharge, short-circuit or burn out components on the PCB.
• Make sure the installation position is stable before you fix the light. When the light is reverse
hanging, make sure the light will not fall from the truss. Pass a safety cable through the truss
and bracket of the light as an extra support to avoid the light to fall down. Don't access to the
work area during mounting. Periodically check if the safety cable has fretted away or clamp is
loosened. We cannot be held responsible for inadequate fastening and installation of the unit. It
is not recommended to use the lamp constantly for more than 10 hours.
POWER SUPPLY AND SIGNAL CABLE CONNECTION
1. Mains Power connection
The exclusive plug should be used between the connection of unit and power. Please ensure that the
rated voltage and frequency are accordance with the power supply. The required input voltage and
frequency are: 90-245V~ 50/60Hz
We suggest that every light has an independent switch so that you can turn on or turn off the light
randomly.
Note: the ground wire (yellow/green double-color wire) must be safely connected, the electronic installation must be in accordance with the
related standards
CAUTION: When installing the device, make sure there is no highly inflammable material within a distance of min.5m!
2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of
the slave light. Connect the DIGITAL OUT socket of the master and the IN socket of the slave light,
then, connect the OUT socket to the IN socket of the next light. Ordinal to connect all the lights as
hereafter:
www.afx-light.com
3
EN
Publicité
Table des Matières
