Safety Recommendations; General Guidelines - afx light BEAM1R-MKII Manuel D'utilisation

USER MANUAL
Please read this manual carefully before operating this product.
CAUTION: Do not damage the lamps !
Prior to moving or handling the light effect, the unit MUST be SWITCHED OFF and cool down
for at least 10 minutes. The lamps are not covered by the warranty. Thank you!

SAFETY RECOMMENDATIONS

Thank you for having chosen our AFX LIGHT MOVING HEAD WITH DMX CONTROL. For your own
safety, please read this user manual carefully before installing the device.
• If the device has been exposed to temperature changes due to environmental changes, do not
switch it on immediately. The arising condensation could damage the device. Leave the device
switched off until it has reached room temperature.
• Don't move the unit when it's running as this might damage the lamp. The warranty doesn't
cover this type of damage that is caused by wrong use.
• It is essential that the device is earthed. A qualified person must carry out the electric connec-
tion.
• Make sure that the available voltage is not higher than stated at the end of this manual.
• Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or au-
thorized agent to replace the power cord.
• Always disconnect from the mains, when the device is not in use or before cleaning it. Only han-
dle the power cord by the plug. Never pull out the plug by tugging the power cord.
• During initial start-up, some smoke or smell may arise. This is normal and should decrease gra-
dually.
• DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
• Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to
such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
• Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to
such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
• The lamp shall be changed if it has become damaged or thermally deformed
CAUTION:
1. Be very careful during installation. Since you will be working with a dangerous voltage you can
suffer a life-threatening electric shock when touching live wired.
2. Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
3. Please be aware that damages caused by manual modifications to the device are not subject to
warranty. Keep away from children and non-professionals.
4. The light doesn't include any spare parts for repair, please check if all the parts are well installed
and screws are fitted tightly before operating. Do not use the light when the cover is open.

GENERAL GUIDELINES

• This device is only allowed to be operated with an alternating current of max. 90-245V~/50-
60Hz and was designed for indoor use only.
• Do not shake the device. Avoid brute force when installing or operating it.
• When choosing the installation spot, please make sure that the device is not exposed to extre-
me heat, moisture or dust. The minimum distance between the projector and the installation wall
EN 2 © Copyright LOTRONIC 2020