Getting Started - Bellman Visit 868 Mode D'emploi

42
Bellman Visit 868 Wrist Receiver, BE1560 and
Bellman Visit Wrist Receiver Charger, BE1570
Introduction
Thank you for choosing products from Bellman & Symfon.
The Bellman Visit 868 System consists of a number of radio
transmitters and receivers. The transmitters detect different events in
the surrounding area and transmit a radio signal to the receivers. The
receivers pick up this signal and provide indications using light, sound
and/or vibration.
The transmitter determines what type of light, sound or vibration
should be displayed so that the reason for the indication is evident.
Read through the entire user manual fi rst and then start to install the
system.
Refer to the illustration of the Bellman Visit 868 System on the inside of
the cover.

Getting started

Unpacking, installing and testing the unit
The Charger is usually placed on a level surface and the Wrist Receiver
should normally be fastened around the wrist or placed in the Charger.
1. Remove the small paper tab sticking out of the battery cover (9) and
connect the power supply unit to the mains voltage and to the power
supply unit socket rst (15). The green LED (10) should come on
and stay on as long as the Charger is powered by an external power
supply.
2. Place the Wrist Receiver in the Wrist Receiver Charger. The green
LED (12) should light up. If the battery is completely fl at, the Wrist
Receiver starts up but can only be used when placed in the Charger
until it has been charged for approximately two hours.