Advanced Programming - Bellman Visit 868 Mode D'emploi

116

Advanced programming

Advanced programming provides additional options for those who wish to
make special modifi cations to the Bellman Visit 868 Wrist Receiver.
The idea is that it should be possible to select a completely unique signal
pattern which is linked to activation from a specifi c input on a specifi c
Bellman Visit 868 transmitter. The function works regardless of the Radio
Key settings on the units that are programmed. Please note that, for safety
reasons, the function does not work with the BE1480 Bellman Visit 868
Smoke Alarm.
By using advanced programming of the Bellman Visit 868 Wrist Receiver,
it can be adjusted so that its signal pattern corresponds exactly to what
is required. In other words, an entirely individual signal pattern can be
programmed, such as displaying a permanently lit orange LED and a
constant vibration.
In order to adjust the setting, the Bellman Visit 868 Transmitter to which
the Bellman Visit 868 Wrist Receiver should be adapted must be available.
The transmitter must also be connected so that it can be activated in the
way in which it is intended to be used.
Proceed as follows:
1. Hold down the Function Button (1) on the Bellman Visit 868 Wrist
Receiver until the green j (3) and yellow m (4) LEDs blink
alternately. The Bellman Visit 868 Wrist Receiver will now be in
programming mode for about 30 seconds.
2. Hold down the Function Button (1) at the same time as the relevant
Bellman Visit 868 transmitter is activated in precisely the way in
which it is intended to be used. The yellow LED p (6) will light
up. Note that all inputs are individual, so that it is not possible to use
the test button on a Bellman Visit 868 Telephone Transmitter whose
telephone input will indicate the relevant pattern.
3. Scroll through the different LED options by a short press on the
Function Button (1). Select the relevant indication by holding down the
Function Button (1) until the LED p(6) goes out and starts to shine
with a constant yellow light again.
4. Scroll through the different vibration options by a short press on the
Function Button (1). Select the relevant indication by holding down the
Function Button (1) until the LED p(6) goes out and starts to shine
with a constant yellow light again.
5. The Bellman Visit 868 Wrist Receiver will now show the indication
method programmed. End the display with a short press of the
Function Button (1).