Aligning The Appliance; Electrical Connection - Haier AFE635C J Mode D'emploi

10- Installation
10.6
1.
max 45°
3.
10.7
2 h

10.8 Electrical connection

Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating plate.
▶ the power socket is earthed and no multi-plug or extension.
▶ the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service (see
warranty card).
30

10.6 Aligning the appliance

The appliance should be placed on a flat and solid sur-
face.
1. Tilt the appliance slightly backwards (Fig. 10.6).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
2. frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the door.
10.7 Waiting time
To the maintenance-free lubrication oil is located in the
capsule of the compressor. This oil can get through
the closed pipe system during slanting transport. Be-
fore connecting the appliance to the power supply you
have to wait 2 hours (Fig.10.7) so that the oil runs back
into the capsule.
GB