Victron energy MT 200 Série Guide D'installation Et D'utilisation page 25

The above data applies to all torches with the following exceptions:
torch series
MT 200 Series
MT 300 Series
* Applicable for 3-hose machine cutting torches only. With a two hose cutting torch,
preheat pressure is set by the cuttting oxygen.
** For best results use HC1200C and HC1100C series torches and 3/8" hose when using
a size 6 tip or larger.
*** All pressures are measured at the regulator using 25' x 3/8" hose for tip size 6 and
larger.
High gas withdrawal rates require use of a manifold system of sufficient size to
supply the necessary volume. High gas withdrawal rates may also require use
of a vaporizer.
Always make sure your equipment is rated for the size tip you have selected. A tip
with too much capacity for the equipment can starve or choke the tip. This causes
overheating of the head and a backfire may result. Use only genuine VICTOR
Cutskill or Firepower
®
ensure leak-free connections and balanced equipment.
note:
pre-heat oxygen
N/A
10-50 PSIG
warning
CaUtion
cutting tips, welding nozzles and multi-flame nozzles to
®
7-21
pre-heat Fuel
8 oz. - Up
8 oz. - Up
,
®