Atmor Thermo Pro2 Série Manuel D'instructions page 6

a. Remove the appliance cover. (Heater cover) (figure 3)
b. Mount the unit on the wall with 4 screws at the marked points (figure 4)
c. Make sure the unit is leveled horizontally, with water inlets and outlets at the bottom
(fig.5)
18W
Fig. 3
Do not install upside down
Fig. 5
24kW, 29kW
Fig. 3
Do not install upside down
6
Fig. 5
Fig. 4
or on its side
Fig. 4
or on its side
Fig. 6
Fig. 6
Water Pre-
Filter
Water Pre-
Filter