for_q FQ-AHS 4055 BASIC Mode D'emploi page 99

d) Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left at-
tached to a rotating part of the
power tool may result in personal
injury.
e) Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situa-
tions.
f) Dress properly. Do not wear loose
clothing or jewellery. Keep your
hair, clothing and gloves away
from moving parts. Loose clothes,
jewellery or long hair can be
caught in moving parts.
g) If devices are provided for the con-
nection of dust extraction and col-
lection facilities, ensure these are
connected and properly used. Use
of dust collection can reduce dust-
related hazards.
h) Do not let familiarity gained from
frequent use of tools allow you to
become complacent and ignore
tool safety principles. A careless
action can cause severe injury
within a fraction of a second.
4 POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your ap-
plication. The correct power tool
will do the job better and safer at
the rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be con-
trolled with the switch is danger-
ous and must be repaired.
c) Disconnect the plug from the
power source and/or the battery
pack from the power tool before
making any adjustments, chang-
ing accessories, or storing pow-
er tools. Such preventive safety
measures reduce the risk of start-
ing the power tool accidentally.
d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands
of untrained users.
e) Maintain power tools. Check for
misalignment or binding of mov-
ing parts, breakage of parts and
any other condition that may af-
fect the power tool's operation. If
damaged, have the power tool re-
paired before use. Many accidents
are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working con-
ditions and the work to be per-
formed. Use of the power tool for
operations different from those in-
tended could result in a hazardous
situation.
h) Keep handles and grasping sur-
faces dry, clean and free from oil
and grease. Slippery handles and
grasping surfaces do not allow for
safe handling and control of the
tool in unexpected situations.
5 BATTERY TOOL USE AND CARE
a) Recharge only with the charger
specified by the manufacturer.
A charger that is suitable for one
type of battery pack may create a
risk of fire when used with another
battery pack.
b) Use power tools only with spe-
cifically designated battery packs.
Use of any other battery packs
may create a risk of injury and fire.
EN
99