Elkron TEL600EXT Guide Rapide page 11

Click on OK to confirm. The welcome page will be displayed. Log in again with your new username and password to continue.
Then access the "Network Setting" menu, select the Wireless and proceed with the "Scan WiFi" function to identify the Camera
and pair it with the desired router.
LEARNING PROCEDURE ON THE CONTROL UNITS
1) Enable learning mode on the control unit (see the complete installation manual of the control unit for details).
2) Press and hold the Learn button for about 10 seconds until the YELLOW LED starts blinking rapidly. Refer to the
complete manual of the control unit to complete the learning process. To exit learning state before the 5-minute timeout,
hold the Learn button pressed for 6 seconds. The YELLOW LED will stop blinking rapidly.
NOTE
For programming the camera parameters using its programming interface, refer to the complete camera installation manual
available on the Elkron website. The Finder software needed to identify and locate the camera in the local area network (LAN)
must be downloaded from www.elkron.it in the reserved area dedicated to PC Software Downloads.
PRIVACY MODE
Privacy mode can be used to enable or disable the camera images.
Privacy mode on/off: Hold the Privacy button pressed for 2 seconds until the red LED blinks twice.
LOCAL CAMERA RESTORE PROCEDURE
Run this procedure to reboot the camera and delete the recorded programs and events, returning the settings to the default
settings (including the password):
To restore the camera to its default settings:
Step 1. Disconnect the power by disconnecting the power supply unit.
Step 2. Hold the learn button pressed and connect the power supply unit.
Step 3. Hold the button pressed for at least 30 seconds.
Step 4. Release the button when all 3 LEDs blink 3 times simultaneously and then all switch off.
Step 5. The IP camera has been restored. Wait for it to reboot.
IMPORTANT
After restoring default settings, the camera must be learnt again and reconnected to the network.
INSTALLATION
For its installation, provide an external environment with protection from direct atmospheric agents. The mounting accessories
supplied with the camera are as follows:
Fastening holes
BASE
After choosing the camera installation surface, use the base to mark the fixing holes to be drilled in the wall. See on the next page
how to assemble the accessories.
To connect the camera to the head and adjust it, follow the description below:
The cap (3) contains the joint for adjusting and fixing the orientation of the camera. To make the joint movable in order to find the
desired orientation, turn the joint fixing knob (4) without unscrewing it completely and then pull the fixing block (5) slightly
backwards with respect to the joint, thus unlocking the joint.
N.B. the fixing block only moves a few millimeters.
At this point, move the joint to the desired position and fix it by pushing the fastening block forward, so that the latter stops the
joint and is aligned with the cap. Tighten the knob to lock everything.
1 X 1 X
2 STRAIGHT FITTINGS
Installation screws (1)
Lock ring (2)
Joint fixing knob (4)
Cap (3)
Joint fixing
Lower screw (6)
block (5)
"L"-FITTING HEAD