Connecting The Charger; Connecting The Temperature Sensor - Truma OPTIMA YT S Instructions De Montage

Connecting the charger

Connect the charger to the battery as shown in the connec-
tion diagram (Fig. 1). Ensure that the polarity is correct.
Connect the negative charging current cable (black) to the
negative terminal of the battery and the positive charging
current cable (red) to the positive terminal.
It is advisable for the negative terminal of the battery to be
connected to the vehicle chassis – minimum cross-section
10 mm².
If the Mover® PowerSet is connected to the independent elec-
trical installation of the vehicle, the negative terminal of the
battery must be connected to the vehicle chassis – minimum
cross-section 10 mm².

Connecting the temperature sensor

Fig. 3
The provided temperature sensor must be attached to the bat-
tery housing in the centre of the area of the positive terminal
(having first cleaned the area to which it is to be attached).
Remove the protective film from the self-adhesive Velcro tape
(hook tape with cut-out) and press it firmly onto the desired
location on the battery. Place the sensor in the middle of
the cut-out and fasten in place with the second Velcro tape
(loop tape). Plug the cable from the temperature sensor in-
to the temperature sensor connection on the device (2-pin
connection).
17