Selecting A Location; Connections; Easy Click® Terminal Clamps - Truma OPTIMA YT S Instructions De Montage

Selecting a location

The installation site should be clean, dry and well ventilated.
The housing can heat up to approx. 75°C during operation, so
clearance of at least 100 mm must be left around the device.
In order to provide the minimum all-round clearance of
100 mm, the space provided for the device must have the
following minimum dimensions.
Length: 430 mm / width: 300 mm / height: 150 mm
The space in which the device is installed must have venti-
lation openings at the top and the sides with a total opening
size of 100 cm².
Liquid electrolyte batteries must be installed in a separate box
with ventilation leading to the outside. A separate box is not
required for gel or AGM batteries. Pay attention to the battery
manufacturer's installation instructions.
Attach the device securely using the four fastening screws
provided.
Install the device in such a way that it can be taken out
for separate charging and connected to an external bat-
tery using the Comfort Connect clamp.
The device is designed for use at ambient temperatures of up
to 40°C. If the internal temperature of the device increases
because of lack of air circulation or an ambient temperature
that is too high, the charging current is automatically reduced
in stages.
16

Connections

The supply lines from the battery and mains must be
disconnected before any cables are connected or dis-
connected. Only use the prescribed line cross-sections and
fuse strengths!
Easy clicK® terminal clamps
(red = positive terminal, blue = negative terminal)
Allow batteries to be connected and disconnected quickly by
hand. Suitable for all DIN and SAE connections
Fig. 2
In order to connect the charging cable (Comfort Connect
ring eyelet), the cable is screwed onto the terminal
clamps with the ring eyelets. If the charging cable is not used,
fit the protection cap.