Walter Bio-Circle Maxi 55D600 Mode D'emploi page 7

SOLUTION TEMPERATURE
3. Place unit indoor, on a smooth level surface away from exposure to
direct sunlight.
4. When filling the unit from a drum, ensure the transfer pump being used is clean
and close the drum once done. Fill the tank on Maxi model 55D600 to its normal
operating capacity of up to 120 liters/31.7 gal. Refer to level lines shown on page
10.
5. Plug power cord into properly grounded 3-prong, 120V, 60Hz, outlet protected
by a class A GFCI.
Notes: Do not turn ON the cleaning pump switch (F) with no liquid inside
the machine.
6. This note applies to Bio-Circle
to warm the Bio-Circle solution to working temperature for optimal cleaning
efficiency. This can take up to 5 hours. 55D600. Once the solution has reached
its proper working temperature of 41ºC/106 °F, periodically, the heater will turn
itself ON automatically to maintain the proper working temperature.
Never turn OFF the BIO-CIRCLE unit except for servicing.
TM
MAXI (55D600) model. Allow the heater coil
7
8