Waste Disposal; Troubleshooting Guide - Walter Bio-Circle Maxi 55D600 Mode D'emploi

WASTE DISPOSAL

Refer to WALTER Safety Data Sheet for
Circle™ Ultra (L-148), and Bio-Circle™ Aero (L-161).
https://www.walter.com/support/MSDS
Used Bio-Circle™ L and Bio-Circle™ Ultra can usually be added to your
other oil-water waste (such as water soluble cutting fluids) for disposal. Always
dispose of residual waste in compliance with Federal, Provincial, State and
local environmental regulations. Check with local authorities for any special
regulatory considerations. Walter Surfaces Technologies accepts no
responsibility or liability for user's failure to comply with governmental and
other safety regulations.

TROUBLESHOOTING GUIDE

SINK FILLS UP
The sink will fill up if the grated receptacle or magnet item (item H on
pages 5 and 9 ) is dirty or clogged. Remove grated receptacle and clean
all parts. Ensure the drain damper moves freely.
WEAK OR NO LIQUID FLOW FROM NOZZLE OR FLOW-THROUGH
BRUSH
The rubber hose may be pinched along its length. Ensure the
hose is not kinked or squeezed. Also, filter item (item D on page
5) could be dirty or clogged, remove filter cartridge and replace
with a new one. See the section "ACCESSORIES" for a listing of
available filter cartridges.
2
Bio-Circle™ L (L-78), Bio-
13