Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna PP 325 E Manuel D'utilisation

Before starting

Make sure that:
• The machine is correctly connected to a suitable power
supply and correctly fused.
• The hoses have been connected to a device.

Starting

NOTICE! When starting, the switch must only be turned to
"START 5 SEC" for about 5 seconds. The switch is then
turned to "RUN". The engine may be damaged if the switch
is in the "START 5 SEC" position too long or when operated.
The engine is started with a Y/D switch. The start takes place
in two steps to avoid overloading the fuse the machine is
connected to.
• Turn the switch to "START 5 SEC" in the direction
indicated by the lit lamp. The direction of rotation of the
engine will then be correct.
• Turn the switch to "RUN" when the engine speed is
constant after about 5 seconds.
10 –
English

STARTING AND STOPPING

• Open the tap to suitable water flow for the tool in question.
If the tool does not require water, cooling water should still
flow through the radiator, and then to the closest floor
drain.

Stopping

Switch off by turning the switch to "0".

After work is completed

• Disconnect the hydraulic hoses.
• If there is a risk of freezing, the machine must be drained
of any remaining water coolant. Disconnect incoming and
outgoing water hoses and tilt the machine forwards.