Table des Matières
Publicité
Anleitung BT 450 AlphaTools
Make sure you stand squarely and keep your
balance at all times.
Check the tool for possible damage!
Each time before re-using the tool, carefully
check that the guards or any slightly damaged
parts are working as intended.
Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted
correctly and that all other operating conditions
are properly fulfilled.
Unless otherwise stated in the operating
instructions, damaged guards and parts have to
be repaired or replaced by an authorized service
center.
Have damaged switches replaced by a customer
service workshop.
This tool complies with the pertinent safety
regulations.
The maximum gap between the sanding/grinding
disk (13) and the sanding/grinding table (14)
must not be allowed to exceed 1.6 mm.
Always use the stop rail (12) or sanding/grinding
table (14) when working.
Please also comply with the general safety
instructions contained in the supplementary
sheet!
Caution!
Read the operating instructions
before using for the first time
Protect from the rain and damp
or wet conditions
Wear work gloves
Wear goggles
28.04.2006
10:17 Uhr
Seite 11
Wear a breathing mask
5. Technical data
Voltage:
Power rating:
375 W S2 30 min
Sanding/grinding disk:
n
:
0
Diameter:
Swivel range:
Cross stop:
Belt sanding/grinding unit:
v
:
0
Size:
915 x 100 mm
Sound pressure level LPA:
Sound pressure level LWA:
Load factor:
A load factor of S2 30 min (intermittent periodic
duty) means that you may operate the motor
continuously at its nominal power level (375 W)
for no longer than the time stipulated on the
specifications label (30 minutes ON period).
If you fail to observe this time limit the motor will
overheat. During the OFF period the motor will
cool again to its starting temperature.
6. Before putting the machine into
operation
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong stand.
All the covers and safety devices have to be
properly fitted before the machine is switched
on.
The sanding/grinding belt and sanding/grinding
disk must be able to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the sanding/grinding paper is correctly fitted
GB
230V ~ 50Hz
1400 min
-1
150 mm
0°-45°
-60° to + 60°
4.6 m/s
78,6 db(A)
91,6 dB(A)
11
Publicité
Table des Matières
