INSTALLATION
Encombrement du poste téléphonique / Dimension drawing
NOTA : Nous recommandons vivement l'utilisation d'une visseuse sans fil réglée avec un couple de
serrage « moyen/fort » (5 Nm MAXI), surtout lors de la fermeture du couvercle, ceci afin d'assurer
une compression homogène du joint d'étanchéité du boitier en respectant l'ordre A B C D.
In order to close the set, correctly put on 2 sides of the post and tighten the 4 screws in the order of
A,B,C,D, without forcing.
Note : Make sure the proper implementation of sealing of the set when fitting it.
If you use an electric screwdriver, adjust the in the position middle.
Démontage préalable avant installation
Pour effectuer l'installation et avoir accès au circuit téléphonique, dévisser les 4 points de fixation de la face
avant (A-B-C-D) * à l'aide d'une clé ALLEN #5 puis extraire la face avant en veillant à ne pas endommager
les composants internes.
* A-B-C-D : ordre de vissage à respecter lors de la fermeture de la face avant du poste afin d'assurer une
compression optimale du joint d'étanchéité.
Ø Récupérer à l'intérieur le sachet plastique comprenant 4 rondelles étanches pour la fixation du boitier.
Ø Procéder au montage du boitier de préférence sur une surface plane.
Ø Se conformer au plan de montage ci-contre et utiliser impérativement les rondelles d'étanchéité Ø6.
NOTA : Nous vous conseillons d'utiliser des vis en acier inoxydable avec les rondelles d'étanchéité.
Prior disassembly prior to installation
To install and access the phone system, remove the 4 mounting points on the front (ABCD) * using an Allen
wrench # 5 and then extracting the front taking care not to damage the internal
* ABCD: screwing around to follow when closing the front of the post to ensure optimal compression seal
Ø Get inside the plastic bag with 4 sealing washers for attaching the case.
Ø Assemble the housing on a flat surface preferably.
Ø Refer to the template, use the watertight gaskets type AZ diam. 6mm for wall mounting
NB : The wall mounting must be done with stainless steel screws.
NFC237A*TEL1-BE
\\SERVEUR MAX\\ Notices NFC \ NFC237A \ NFC237A-TEL1-BE.DOC
8 / 12