Standards And Regulations - LBX instruments H03D Mode D'emploi

10. Standards and Regulations

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference. In that case, the user will be
required to correct the interference at his own expense.
Note:
•
Electronic devices cannot be cleaned with
cleanser.
•
If maintenance service is needed, the
instrument must be cleaned in advance to
avoid pollution from hazardous substances,
and sent back in the original packing.
•
If the instrument will not be used for a long
time, please switch off and place in a dry,
clean location, at room temperature, and on
a stable surface.
Construction in accordance with the following safety
standards:
EN 61010-1
UL 3101-1
CAN/CSA C22.2(1010-1)
EN 61010-2-10
Construction in accordance with the following EMC
standards:
EN 61326-1
Associated EU guidelines:
EMC-guidelines: 2004/108/CE
Instrument guidelines: 73/023/EWG
12