Operating; Cleaning And Maintenance - LBX instruments V03 Serie Manuel D'utilisation

5. Operating

▪
Place the equipment on a flat and steady surface that can support the equipment's weight leaving
30 free cm on each side.
▪
Connect the device's power adapter to the electric network.
▪
Push gently the test tube into the Vortex soft area.
▪
To stop the process, just lift up the test tube.
6. Faults
▪
The equipment does not start.
Make sure the power supply is working.
-
Make sure the cable is plugged in.
-
If these faults are not solved, contact the supplier/manufacturer.

7. Cleaning and maintenance

▪
The Vortex mixer is maintenance-free.
▪
Do not spray cleaning agents directly onto the equipment. Always use an impregnated cloth or tissue
▪
Disconnect the equipment from the power supply while cleaning.
▪ Use only the recommended cleaning agents for each situation:
Dyes
Construction materials
Cosmetics
Food products
Fuels
▪
Before using any other cleaning agents or decontamination methods, verify with the manufacturer
or supplier if the chosen method will not harm the equipment. Protective gloves shall be worn while
cleaning.
Water containing tensides / Isopropyl alcohol
Water containing tensides / Isopropyl alcohol
Note:
• Electronic devices may not be cleaned with cleanser.
• If maintenance service is needed, the equipment must be cleaned
prior to shipping, to avoid pollution from hazardous substances,
and shipped in its original packaging.
• If the equipment will not be used for a long time, power off and
place in a dry, clean, steady location at room temperature.
Isopropyl alcohol
Water containing tenside
Water containing tenside
5