Connecting And Cabling; Testing Signal And Power Connections; Using The Vivid 4 Test Button - Chauvet DJ Vivid 4x4 Mode D'emploi

Connecting and Cabling

6. Connecting and Cabling

Testing Signal and Power Connections

Each Vivid 4 has 2 power sockets and 2 signal ports.
• The Power and Signal connections are located on the underside of the service module of each
panel.
• The Signal ports may be used interchangeably.
• Each Vivid 4 has LED indicator lights on the test button in the center of the panel.
• Each panel indicates a successful power connection when the Power indicator light remains red.
• Each panel indicates the presence of a signal when the Signal LED indicator light blinks green
quickly. When the LED blinks green slowly, there is no signal.
Rear Panel View

Using the Vivid 4 Test Button

Each Vivid 4 has a Test button, used to ensure all LEDs are functional. Use the Test button on each panel
to perform a self-test. If self-testing, you must perform the test individually for each Vivid 4. You do not
need to connect to a signal or use software.
When using the Test button, make sure the Vivid 4 is NOT connected to the
Vivid Drive 23N.
To use the Test button, you must connect the power, but do not connect the signal cables. Press the Test
button to toggle through various LED light display configurations.
Vivid 4 X4 User Manual Rev. 4
Underside of Service Access View
Test Button
Power/Signal
Indicator LEDs
Signal Connections
Power In/Out
16