Alarm Mode; Alarm Function; Snooze Function; Disposal - Sonoro Audio Cubo Mode D'emploi

9. Alarm mode

9.1 Alarm function

The alarm can be set to start at 2 different times.
1. Press and hold one of the two alarm buttons until the time display starts to flash.
2. Use the tuning controls to set the hours.
3. Use the volume controls to set the minutes.
4. Save your setting by pressing the corresponding
5. Next, use the VOLUME +/- button to select the mode to be activated by the alarm: CD, DAB,
FM, AUX* or Beep. Then confirm these with the corresponding ALARM button.
6. If you use DAB or FM (radio) as your alarm: press the
radio station buttons (1- 6) or the "FAVORITE" button on your remote control to select the
desired radio station.
7. If you use the CD as your alarm: use the
shortcut to the CD track number can also be selected with the 6 preset radio station buttons (1-6).
8. Save your setting by pressing the corresponding
9. Select the desired volume using the volume control buttons.
10. Save the alarm mode by pressing the corresponding
* Please ensure that a device set to playback is connected.
To switch the alarm on or off, briefly press the STANDBY or ALARM button
To interrupt the alarm, press the SNOOZE button.

9.2 Snooze function

The SNOOZE time can be adjusted. With the device switched off, press and hold down the
SNOOZE button. Select the desired snooze time and save your selection by pressing the
SNOOZE button.
During the alarm time you can adjust the snooze time with the VOLUME+/- buttons
after pressing the SNOOZE button twice. Confirm the snooze time by pressing the
SNOOZE button again.

10. Disposal

10.1 Packaging

The packaging of your designer cubo CD/DAB+/DAB radio protects it against
damage during transport. The packaging consists of raw material that can be re-used
or recycled.
ALARM button.
VOLUME +/- buttons, one of the preset
VOLUME +/- buttons to select the desired track number. A
ALARM button.
ALARM button.
17