Operation; Battery Compartment; Insertion And Removal Of Disks - Sonoro Audio Cubo Mode D'emploi

1.4 Operation

Connect the power supply to an easily accessible mains outlet.

1.5 Battery compartment

This cubo model has a replaceable battery (CLOCK BATTERY) to back up the clock memory.
This means if the power supply is interrupted, e.g. in the event of a power failure, the alarm
and clock settings are saved. The entire display lighting and the alarm functions are switched off.
As soon as power returns, the correct time will be displayed and the alarm function reactivated.
The battery has a plastic film cover when you purchase the unit. Remove this film to activate
the backup battery.
Note: If no backup battery is inserted you will have to set the clock and alarm times after the
power supply has been interrupted. If the power supply is only interrupted rarely, the service
life of the battery will depend on the battery's durability. The battery should be replaced
approximately every two years to avoid potential leaks. To do this, release the screws at the
rear of the device (see illustration on page 9), replace the battery and then tighten the screws
again. The battery is not included in the guarantee.
Batteries contain chemicals and should be disposed of properly.
Caution! Risk of explosion if the wrong battery type is used. Please replace with a battery of
the same or similar type (3V lithium battery, type CR2032).

1.6 Insertion and removal of disks

Insert a CD with the label facing upwards into the CD slot. To remove the CD again,
press the OPEN button.
Warning: Never insert a mini CD / MD-CD (8-cm diameter) into the CD slot.
NO MINI CD!
6