Lamp; Usb Port; Charge Level Of The Battery; Recharge The Booster Using The Ac/Dc 230/12V Charger - MAXTOOLS JS500 Mode D'emploi

English

2.2 Lamp

The Booster is provided with a pivoting lamp. To light it, push simply on the left push-
button. For security reasons, the lamp will stop lighting from the moment you release
the push button.

2.3 USB port

The USB port can be used as output power or recharge devices like cell phones and
other electronic devices, The values are DC 5V 500mA. The USB port will work if
the battery level button is in ON position.

2.4 Charge level of the battery

Press the right push-button to show the charge level of the battery of the Booster and
then press again to OFF position after checking.
Half an hour after disconnecting the recharge cable from the Booster, the charge
level must be in the green area.
If the recharge state is:
Green: your Booster is charged.
Yellow: you must recharge your Booster.
Red: you must urgently recharge your Booster.

2.5 Recharge the Booster using the AC/DC 230/12V charger

NEVER wait until the Booster is completely discharged before recharging.
An electronic full automatic charger AC/DC 230/12V is integrated in the Booster.
Connect the recharge cable to the sector AC 230V, then connect the recharge cable to
the Booster via the recharge plug on the back side of the Booster. The recharge led will
light up. Please note the recharge led will light up in red if the battery is low and the led
will become green once the battery is charged. The Booster can be left permanently
in charge.
The booster must always be recharged in well-ventilated places and
away from easily inflammable materials.
10