Technical Data - Ferm DSM1009 Traduction De La Notice Originale

Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/3A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No-load speed
Protection class
Weight
NOISE AND VIBRATION
Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your delta sander has been designed for sanding
wood, metal, plastics and painted surfaces.
1. On/off switch
2. Speed adjustment wheel
3. Sanding pad
4. Grip
5. Dust extraction connection
ASSEMBLY
V~ 230-240
Mounting and removing the sanding paper
Hz 50
(fig. B)
W 280
Mounting
min 6000 - 11000
-1
● Mount sanding paper (6) with the required
IP 20
grain size onto the sanding pad (3). Make sure
kg 1.2
that the perforation in the sanding paper (6)
corresponds with the perforation on the
sanding pad (3).
dB(A) 79
- Use coarse sanding paper (grain 50) for
dB(A) 90
dB(A) 3
- Use medium sanding paper (grain 80) for
m/s 9.7
2
m/s 1.5
2
- Use fine sanding paper (grain 120) for
Removing
● Remove the sanding paper (6) from the
sanding pad (3).
USE
Switching on and off (fig. A)
● To switch on the machine, slide the on/off
switch (1) to the front.
● To switch off the machine, slide the on/off
switch (1) to the rear.
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
sanding rough, uneven surfaces.
removing the remaining scratches from the
coarse sanding paper.
finishing surfaces.
5