Operation By Remote Control - Bigben TORTUE Mode D'emploi

Operation by remote control

Brightness and speed buttons: Adjust speed in "SMOOTH" mode (automatic scrolling),
1
and adjust brightness once colour is set.
Light activation button: Press this button to switch the light on or off. Once switched
2
on, press the activation button again to switch the light off. This button does not affect
Bluetooth function. This speaker has a memory storage function that works as long as
the battery still has charge: It display the last lighting mode or colour used before being
switched off. For example, if the speaker was in "RED" mode when you switched it off, it
will remain in this mode when you switch it on. This function cannot be used if there is no
remaining charge in the battery. Once battery is fully recharged, the default setting when
you press the activation button is "SMOOTH" mode.
Short-press this button to turn Bluetooth on and off, and long-press it to pair. This button
3
does not affect the light activation function.
Short-press: Short-press this button to enable and disable the Bluetooth function. Once
activated, the Bluetooth indicator light flashes blue and the beep announces that the
Bluetooth function is enabled.
Long-pressing the Bluetooth button is only for pairing operations.
(Notice 1: Each time you wish to pair, you must long-press the Bluetooth button and point
at any of the speakers. If you point at more than 1 and long-press the Bluetooth button at
the same time, it will fail to pair.
The remote can control 1 selected speaker only. After the speakers are paired, the remote
can control both speakers.
Notice 2: If you fail to pair them again, you can cancel the previous pairing by long-
pressing the Bluetooth button on the remote or long-pressing the ON/OFF switch on the
bottom until you hear 2 bips)
When the 2 speakers are paired and playing music, if you move the master more than 8
meters away from the Bluetooth device, the Bluetooth indicator light on the master will
start fast flashing blue again and a beep will announce that both master and vice speaker
are disconnected: Your Bluetooth device and the speaker will no longer be connected,
Music will stop playing too. Now you need to restore 2 speakers to playing music within
8 meters.
If you move the vice more than 8 meters away from Bluetooth device, the vice Bluetooth
indicator light on the vice will start fast flashing blue and a beep will announce that only
the vice speaker is disconnected, but the master will still play music, if the return vice
is within 8 meters of the master, then they can be paired automatically and play music
again.
The Bluetooth indicator light is located inside the speaker and under the speaker housing.
When the Bluetooth function is activated, press the button again to switch off and the
Bluetooth indicator light will turn off too. It is OK to connect the unit speaker and play
music when not using the pair function.
Color buttons: Once the light is turned on, press one of these buttons to choose your
4
favorite color from the six colors shown on remote control.
5
Cold white light button: press this button to make color a colder white (7 levels).
6
Warm white light button: press this button to make color warmer (7 levels).
Color selection button: Once the light is on, use this button to select your favorite color,
7
from the 7 colors available.
8 Flash button: The light automatically flashes with the beating music.
9 Smooth button (automatic scrolling): scrolls through 7 colors automatically.
- EN 4 -